Python Remote Not Locking Doors

In december i had a remote start installed in my truck and am using the original truck key fobs to start the truck.

Python remote not locking doors.

Look on the back of your remote for the proper buttons to press to enter and exit valet mode usually lock trunk. The key fob itself could be defective or have a bad unlock button. Most of our remote starters go into valet mode by pressing a combination of two buttons on the remote control for 1 2 second. Its hard to do with it working but you want to try to find the small gauge want to say 16 or 18 blue and green wires coming off the alarm brain.

Your remote might also have lost programming. If your remote has usb port plug it into a usb charger and then try again later. Even if you forget to arm the system passive arming will protect the vehicle from would be thieves. Check the remote antenna inside of your vehicle.

Also the vehicle would not shut off when i took the key out of the ignition had to repeat it to get the car to shut off. Sometimes after the battery in the car or remote start fob has been changed the fob won t work until it has been reset. Try reprogramming your remotes. Make sure that the connecting harness is fully secured.

Python s remote start system allows users to operate their power locks and start their vehicle with the simple push of a button. If lock unlock does work please proceed to the next troubleshooting step. Check your connections there. If it unlocks the door the problem may be a weak battery in the key fob or a problem in the keyless entry antenna or wiring.

When you press these buttons the parking lights should flash two times. I used the remote start almost daily without any issue. If you own one of the high end compustar remotes that have internal batteries then it needs to be charged. These should be going to a blue green wire lock and a yellow red wire unlock in the driver side kickpanel.

The fob would not lock or unlock the doors. Try holding the fob right next to the door handle when pressing the unlock button. Then the daylight running headlights would not work or the keyless entry. Step 1 sit in the driver s seat and close all of the doors.

Python remote starter wont start the vehicle doors will not unlock with the remote or start the car but will arm the alarm. If the remote is not responding to you there is a good possibility you just need a battery for it. These are your lock and unlock wires blue unlock. In january i remote started my truck and when i went to get into the vehicle the key fob did not open the door.

This feature can be used in conjunction with power door locks and windows to fully secure the vehicle.