Open the access panel of the clock case where the pendulum is located.
Pendulum wall clock adjustment.
Adjust the pendulum up or down.
To level a wall mounted clock move the bottom of the clock casing to the left or right no more than 1 5 mm 1 16 inch.
A pendulum too high causes the clock to run fast.
Adjustment on the dial if your clock has a small arbor protruding the dial near the 12 or the 6 or perhaps in.
Move the nut up or down depending if it.
Too low causes the clock to run slow.
2 look at the clock again exactly 24 hours later and see if it is fast or slow.
The first type is obvious.
Locate the adjustable weight or screw mechanism near the pendulum arm.
Adjust your pendulum clock to the correct time and then set the clock on a level surface and check that it is wound.
If space restrictions do not allow the level to rest under.
Place the circular bubble level beneath the pendulum.
Push the weights to see that they are working correctly with the pendulum.
Adjustment nut on the pendulum if your clock has a small nut on the bottom or another place on of the pendulum then.
Set the grandfather clock correctly by using.
To speed the grandfather clock up move the pendulum disk up by turning the adjustment nut to the right.
Adjust the speed of the pendulum and clock by moving the pendulum adjustment nut.
To slow the grandfather clock down move the pendulum disk down by turning the adjustment nut to the left.
Look on the bottom of the weights where they are marked left right and center.
Posted on february 25 2012 by clockde 1 start by seeing exactly how far off the time is over a 24 hour period.
How to adjust a pendulum clock escapement step 1.
The pendulum bob or weight with a threaded adjustment to lower or raise the bob and movements that have an adjustable platform at the top of the suspension spring.
Next you need to stop the pendulum and.
There is either a threaded nut under the pendulum bob weight or a knurled wheel in the center of the bob.
If the pendulum is in motion bring it to.
The pendulum disk is moved up or down by turning the adjustment nut.
3 look at.